Update 2/5/24:

I have noticed that sometimes the hook at the bottom gets in the way of the y-axis slider, therefore I have removed the hook to prevent the mount from being knocked off. The model is now replaced. For now please use thin double-sided tape to hold the mount in place. I will come up will a new one asap.

Descriptions:

This is a mount for a USB webcam to act as the monitoring camera of the AD5M since it doesn't come with one. I found a webcam that I had no use with and wondered if FF's firmware supports it, and realized that since it's based on Klipper, any USB webcam that clamps on top of a monitor will work for this machine. So I designed this mount to let the camera clamp in place without interfering with the tool head.

A tiny bit of support may be needed at the pin.

The pin goes into the hole next to the screen, on the right side of the printer. To make it fit in the middle hole, just simply mirror the part in your slicer and your camera should be centered. Same thing applies if you prefer mounting your camera on the left side of the printer.

Let me know if you need mounts of other height or width.

Happy printing and don't forget to share your makes!