Flashforge Adventurer 5M - Bambu Lab X1 hotend mod
This is a Remix:
model by @myxxx323
changes:
The hotend fan is installed from the outside. Fasteners M3 or M2.5
The thickness of the bottom wall (from the hotend side) and the ventilation grille has been increased, a stiffener has been added to the side walls.
A couple of changes in cable management, other minor changes.
The "membrane" model prints holes on bridges better. They must be removed with a knife or hot soldering iron.
M3x5mm (OD 4.5mm), fan - 2x M3x5mm (OD 4mm) and/or 2x M2.5x5mm (OD 3.5mm)
| carriage_X_axis_-_no_membrane.stl | 20.6MB | |
| carriage_X_axis_-_with_membranes.stl | 6.2MB |
