1kg filament spool holder upgrade for the FlashForge Adventurer 3 as the standard only holds at most a 500g spool.
Fits very well to the existing spool holder on the printer.
It is an 8 hour and 31 minute print with the standard print settings on FlashPrint.
I have included the following:
STL - file of the object
FPP - file for correct print orientation for customisable build settings.
100mm wide spool holder added. In two parts as it will not fit inside the 150x150x150mm Adventurer 3 build volume.
GX - file to print with the setting I used successfully (8:31 print time with a 0.18mm layers)
Just got my hands on the newer Aventurer3 which has a diferent factory spool holder
Now I have included a new design which fits both types of machines. (early model has a different mounting point to the newer design) It is called "Spool Holder Mark 2"
I currently printing the test of it with 30% infil with the 0.18 layer height.
I have updated the design again as it was a very tight fit.
Mark 4 is the lastest version. The GX file has sacrificial parts included to suport the print as I'm printing it standing on the holster.
This one fits the best as older versions were a bit tight
| SpoolHoldertest100mmA.stl | 608.5KB | |
| SpoolHoldertest100mmB.stl | 133.8KB | |
| SpoolHoldertestc.fpp | 534.1KB | |
| SpoolHoldertestc.gx | 19.5MB | |
| SpoolHoldertestc.stl | 651.9KB | |
| Spool_Holder_Mark_4.stl | 1.7MB |
