Flap Lock Base For Camper 3D Printer Model
The file 'Flap Lock Base For Camper 3D Printer Model' is (stl) file type, size is 1.1MB.
The file 'Flap Lock Base For Camper 3D Printer Model' is (stl) file type, size is 1.1MB.
Often used lock for all kind of camping vehicles.
This I needed for the boat of an old sidecar motorbike.
The old lock was lost an there remain just a hole.
This piece allow to mount a new lock.
Used M5 Allen screws wit a square nut (slide in from the side). Screw comes from the back,
that increases the safety a bit.
There is the variant (V2) of the lower lock. Is saves 5mm of space.
| lower_lock.stl | 172.9KB | |
| lower_lock_v2.stl | 2.4MB | |
| upper_lock.stl | 628.8KB |
