FJR1300A Hand Guard Bracket 3D Printer Model
The file 'FJR1300A Hand Guard Bracket 3D Printer Model' is (stl) file type, size is 851.5KB.
The file 'FJR1300A Hand Guard Bracket 3D Printer Model' is (stl) file type, size is 851.5KB.
A bracket to fit generic hand guards on the FJR1300A. Due to not having mirrors that come from the handlebar stems on the FJR, many handguards will not fit. So I made a set of my own.
The models are built from scratch using digital calipers as a measuring device on my own FJR1300A 2010 model. Each FJR1300 my vary slightly.
The poles are for the centre support to act as a balancer against the break/clutch levers.
The pole has 2 main settings depending on the rider. The furthest hole I found wasn't quite snug enough. I was going to remove it but decided to keep it for others. The second hole allows for minor adjustements depending on your hand size.
I also added the complete setup, including nuts, washers, and bolts to use if required.
| FJR1300A_Hand_Guard_Bracket.stl | 92.4KB | |
| FJR1300A_Hand_Guard_Bracket_bolt.stl | 970.2KB | |
| FJR1300A_Hand_Guard_Bracket_brace.stl | 21.1KB | |
| FJR1300A_Hand_Guard_Bracket_complete.stl | 1.1MB | |
| FJR1300A_Hand_Guard_Bracket_nuts.stl | 20.4KB | |
| FJR1300A_Hand_Guard_Bracket_washers.stl | 31.3KB |
