I made this center console cover for my FJ Cruiser (2007). The inside ridges are slightly smaller than the box itself, so there is slight side to side and front to back play. I left a small gap so a USB cable could be ran out of the box with the lid on. Blender file is included if you want to adjust that. I printed with PETG with a 1mm nozzle, 1mm wide lines, 0.6mm tall lines, 6 wall lines, 6 solid top / bottom layers, 25% infill. It came out to about 500g and I have no worries about the kid / dogs breaking it. I put 4 small pieces of velcro in the four corners. This makes sure it stays put, and it also helps the cover sit level (the console box itself has a slight convex curve, so it would otherwise have a slight wobble sitting on the high point in the middle).
| FJCC_20200113.blend | 625.5KB | |
| FJCC_20200113.stl | 5.0MB |
