This lovely model is not mine. All props to the original creator. All I did was slice a tiny bit off the bottom to make it printable without work. It loads into my slicer with no problems and you can see a screenshot of the first layer with a 0.44mm line width. If the Thingiverse preview shows it on its side, ignore that. It will be the right way up in the slicer with the feet and trunk flat on the bed. The original file had to be rotated in my slicer. If you look at the screenshot you can see the blue dots are where the original and my tweaked version touch the bed. Quite a difference as the original is floating on the air and just resting on a tiny point on the trunk! :)
| elefanteB_fixed.STL | 4.0MB |
