FIXED Remix Of Fred The Frog Gravitrax Piece By Kroy123 (READ SUMMARY!) 3D Printer Model
The file 'FIXED Remix Of Fred The Frog Gravitrax Piece By Kroy123 (READ SUMMARY!) 3D Printer Model' is (stl) file type, size is 1.0MB.
The file 'FIXED Remix Of Fred The Frog Gravitrax Piece By Kroy123 (READ SUMMARY!) 3D Printer Model' is (stl) file type, size is 1.0MB.
Feedback to the original:
So a marble comes along the track and falls into Fred's mouth, where it falls along the track and joins up again. However, the mergers (joiners) have a FLAW in it. I printed out the original version but marbles sometimes ended up getting stuck at the joiners. So I have to use https://www.thingiverse.com/thing:4082378 in order to get it working. But it just wastes a bit too much height. Also, the plan for the base is missing for one of the grooves designed to fit a "ring" compatible to Gravitrax.
Summary:
I went to F360 (Fusion 360) to upload a mesh file, and then sealed these holes to get it working so that it doesn't act like a end tile.
IMPORTANT: Before printing, make sure that you "cut" the ring on Fred's butt because the two hexagons are misaligned at 30 degrees instead of 60. That's the function I use in my Bambu Studio. You also need to glue these two hexagons that are cut.
Note that this is a Work-In-Progress, as I'm not sure whether it's 100% working or not!
Ring is taken from: https://www.thingiverse.com/thing:6233909
| Cool_Kasi_V2.stl | 2.4MB | |
| Ring_1.stl | 124.0KB |
