The file 'Fishing Rod Rest Pack, Buzz Bars, Method Feeder Single And Multi Rod Rest, Rod Butt Rear Rest 3D Printer Model' is (stl) file type, size is 8.0MB.
This kit contains a set of Buzz Bars, Side Strike multi and single rod holders and a rod butt rest. More rod rest models are in work and will be added when they are finished.
All rod rests, including the BSF 3/8 threaded insert, need to be printed flat down.
The buzz bars will be printed upwards with flat face down.
The threaded insert needs to be glued inside the rod rests/ buzz bars. I recommend using 2 parts epoxy glue.
If you found this project helpful, you can Buy Me a Coffee at the link below :
https://buymeacoffee.com/mars.explorer
UPDATE 14.05.2021
The insert socket for buzz bars and rear rod rest was not deep enough and had to be adjusted.
Added a new version of thread insert.
Added a washer. Flexible filament would make it more adjustable.
| Buzz_BarHolder_Hybrid_200mm.stl | 7.1MB | |
| Buzz_Bar_200mm_Simple.stl | 5.1MB | |
| Method_feeder_holder_1.stl | 207.0KB | |
| Method_feeder_holder_2.stl | 163.6KB | |
| Method_feeder_holder_small.stl | 189.8KB | |
| Method_feeder_multi_holder.stl | 317.0KB | |
| Rod_Butt_Rest_1.stl | 107.3KB | |
| Thread_insertV3.stl | 4.0MB | |
| Universal_holder_1.stl | 268.8KB | |
| Universal_holder_2.stl | 180.5KB | |
| Universal_multi_holder.stl | 187.8KB | |
| Washer.stl | 123.1KB |
