Fishing Rod Holder, High Speed Print, Vertical, Wall Mount 3D Printer Model
The file 'Fishing Rod Holder, High Speed Print, Vertical, Wall Mount 3D Printer Model' is (stl) file type, size is 94.4KB.
The file 'Fishing Rod Holder, High Speed Print, Vertical, Wall Mount 3D Printer Model' is (stl) file type, size is 94.4KB.
Made for holding fishing rods with 35mm (1.4inch) base or less. built for high speed 3d printing (minimal hard corners to reduce vibration and keep speed high) use 4 walls and enough bottom layers to not use infill on the lower part. use infill on the claw part.
good for ultralight to bass rods I'm working on a new design for catfish and trolling rods
Inspired by brooktrout but completely redesigned from scratch as his model is not high speed print friendly, uses too much plastic, and sometimes cracks at screw holes this model should print in 60 percent of the time and 44 percent less plastic.
| Fishing_Rod_Holder_base_part1_v4.stl | 250.3KB | |
| Fishing_Rod_Holder_Part_2_gen_2_idea_v4.stl | 181.5KB |
