This is a fishing rod. It is better to use PLA due to less shrinkage. Infill 50%. Resolution is 0,2 mm. The reel consists of several parts to print without supports to ensure clean surfaces. The parts of reel fix with glue or epoxy glue. The rod is printing with support. I used a screw (M5*16) with nut to connect reel and rod. Nut fix with glue. The alerter bite is on the end of the rod.
| _Зимняя_Катушка_1.STL | 769.8KB | |
| _Зимняя_Катушка_2.STL | 800.6KB | |
| _Зимняя_Катушка_3.STL | 37.6KB | |
| _Зимняя_Ручка_Под_Гайку.STL | 201.2KB | |
| _Зимняя_Удилище_Под_Гайку.STL | 464.6KB |
