This is the third and final version of my fishing reel design and 3D print. I liked the last version, but still thought it could be improved by making it mountable on a rod or stick. Towards that end, I moved the ratcheting button from the top to the back and added a block to the top that you can use to tie the assembly to a rod or stick easily.
To move the button, I had to completely redesign it. I also learned a few things. The "spring" on the button is now curved, which makes it a lot more flexible. And then I doubled it, using two spring tabs to get the strength I needed without the brittlness of a single tab.
Finally, instead of leaving the front open, I enclosed it and used a smaller hole with rounded edges up front.
I have already printed and tested this setup and it works well. I made a few more final tweaks to perfect it and will be posting the pictures of the final assembly when its done.
For assembly, you'll need 11 x 3mmx12mm self taping screws for the body and spool pieces, and one 3mmx20mm screw for the handle.
| bobbin_mk2.ipt | 370.0KB | |
| bobbin_mk2.stl | 412.6KB | |
| bobbin_mk2.stp | 159.9KB | |
| Body_right.ipt | 384.5KB | |
| Body_right.stl | 523.8KB | |
| Body_right.stp | 161.4KB | |
| button_mk2.ipt | 314.0KB | |
| button_mk2.stl | 213.9KB | |
| button_mk2.stp | 118.9KB | |
| Handle_mk2.ipt | 136.0KB | |
| Handle_mk2.stl | 22.2KB | |
| Handle_mk2.stp | 18.2KB | |
| Left_Reel_body_mk2.ipt | 170.0KB | |
| Left_Reel_body_mk2.stl | 204.9KB | |
| Left_Reel_body_mk2.stp | 61.3KB | |
| Left_spool_mk2.ipt | 198.0KB | |
| Left_spool_mk2.stl | 133.7KB | |
| Left_spool_mk2.stp | 98.9KB | |
| Reel_Mk2_Assembled.stl | 262.4KB | |
| Rod_clamp.ipt | 289.5KB | |
| Rod_clamp.stl | 33.3KB | |
| Rod_clamp.stp | 110.3KB |
