Fishing Hooksetter With 3 Different Rod Holders 3D Printer Model
The file 'Fishing Hooksetter With 3 Different Rod Holders 3D Printer Model' is (stl) file type, size is 574.7KB.
The file 'Fishing Hooksetter With 3 Different Rod Holders 3D Printer Model' is (stl) file type, size is 574.7KB.
I found this and thought I could make one and the rod holder. So I did.
I now use this when I go fishing at Henry Hagg Lake in Gaston, Oregon.
I made a rod holder for the bench because if there is a table near the lake you can use the bench rod holder and have it right next to you. Seconds count when you are fishing.
You will need to buy:
1) One or Two, 3 feet long, 3/8" (10 mm) wooden dowel(s).
2) String or small rope.
3) The bottom center 3/8" (10 mm) wooden dowel is 10 inches long.
The filament I used is PETG. Resolution: 0.2, Infill: 90.
I added different height hooksetters: 4mm, 3mm, 2mm
My rod uses 2mm.
I added a extension for the bottom for lake shore fishing. Check out the images.
You will need to print 2 (two) "Hooksetter bottom angle.stl". One for the left side and one for the right side.
You can use this for lake shore fishing or ice fishing.
Fishing Hooksetter Bench Setup:
https://www.youtube.com/watch?v=9lk_ARgveX0
Here is a video of it. Not mine video but a video I found to show you how to set this up and use it.
https://www.youtube.com/watch?v=hzG8eCv2ag4
| Base_Rod_Holder_-_inside_diameter_25mm.stl | 308.2KB | |
| Base_Rod_Holder_-_inside_diameter_32mm.stl | 149.0KB | |
| Base_Rod_Holder_-_inside_diameter_33mm.stl | 254.6KB | |
| Bench_Rod_Holder_-_inside_diameter_32mm.stl | 267.2KB | |
| Hooksetter_2mm.stl | 217.4KB | |
| Hooksetter_3mm.stl | 217.4KB | |
| Hooksetter_4mm.stl | 217.4KB | |
| Hooksetter_bottom_angle.stl | 119.7KB | |
| Hooksetter_bottom_center.stl | 89.8KB |
