This is a case for fingerprint sensor used with arduino or raspberry pi.
It was made on Fusion360 and It was splitted into 3 pieces:
Cover-Sensor.stl (Optional Cover for Fingerprint Sensor)
You need to glue the cover sensor to the lid.
This case is super strong and it uses six M3 screws (4 screws for lid and 2 screws to hold case).
It was printed using a 0.8mm nozzle and with a layer heigth of 0.2mm.
Recommended infill: 25%
You can print with a 0.4mm too, but it will take more time to print.
Don't change object orientation to print it. This one is the best.
Only Top-Case.stl requires support, others are support free.
| Bottom-Case.stl | 106.1KB | |
| Cover-Sensor.stl | 20.4KB | |
| Top-Case.stl | 79.0KB |
