Final Fantasy VII Rebirth Queens Blood Board 3D Printer Model
The file 'Final Fantasy VII Rebirth Queens Blood Board 3D Printer Model' is (stl) file type, size is 1.8MB.
The file 'Final Fantasy VII Rebirth Queens Blood Board 3D Printer Model' is (stl) file type, size is 1.8MB.
A rough model of the Queens' Blood board from Final Fantasy VII Rebirth, including playspaces and areas to drop counters on each side of each lane. The card spaces are slightly bigger than the average playing card to allow them to easily slot in and out as you play.
As such, this model is extremely large and is unlikely to fit naturally on your printer. I have provided suitably sliced files for various printers to make this and put it together. If you have a vary large format printer (> 300mm x 300mm) you may be able to print just qb_board_left.stl, qb_board_mid.stl and qb_board_right.stl, otherwise the numbered/upper/lower partitions of each of these pieces will fit on most printers with a bed >=200mmx200mm,
The pawns should be printed as two separate peices and glued for best results. I recommend printing the ball in transparent resin to really capture the effect as in game.
| qb_board_left.stl | 753.7KB | |
| qb_board_left_lower.stl | 496.4KB | |
| qb_board_left_upper.stl | 491.6KB | |
| qb_board_mid.stl | 663.0KB | |
| qb_board_mid_1.stl | 315.8KB | |
| qb_board_mid_2.stl | 338.9KB | |
| qb_board_mid_3.stl | 306.2KB | |
| qb_board_mid_4.stl | 313.4KB | |
| qb_board_right.stl | 763.5KB | |
| qb_board_right_lower.stl | 478.6KB | |
| qb_board_right_upper.stl | 521.1KB | |
| qb_full_board.stl | 947.7KB | |
| qb_pawn_ball.stl | 59.8KB | |
| qb_pawn_base.stl | 22.2KB |
