Filament Spool Shelf Bracket (with End Stops And Anti-Tangle Clips) 3D Printer Model
The file 'Filament Spool Shelf Bracket (with End Stops And Anti-Tangle Clips) 3D Printer Model' is (stl) file type, size is 392.0KB.
The file 'Filament Spool Shelf Bracket (with End Stops And Anti-Tangle Clips) 3D Printer Model' is (stl) file type, size is 392.0KB.
Added a version for 3/4" dowels per commenter's request.
Store your spools on the wall with this convenient shelf system! Cut wooden dowel rods to whatever length you need for a custom fit in your space. The anti-tangle clips are very easy to use: just clip one onto the dowel at your spool and feed the filament through the small hole. Won't stress or kink your filament! The ridges on the outside make them easy to grip and move.
The optional End Stop clamps on tightly to prevent your spools from toppling off the edge. They require M3x20mm screws and square M3 nuts. See the picture for approximate dimensions.
I mounted mine to wall studs using 2-inch #8 lath (washer head) screws, but sturdy drywall anchors should also work just fine.
Everything is sized for 7/8ths-inch wooden dowels (about 22mm). if you need a different size, leave a comment with your preferred dowel diameter and I'll upload a new version for you.
Happy printing!
| End_Stop_Clamp_3-4ths.stl | 90.7KB | |
| End_Stop_Clamp_7-8ths.stl | 91.3KB | |
| End_Stop_Rail_3-4ths.stl | 230.0KB | |
| End_Stop_Rail_7-8ths.stl | 229.6KB | |
| Filament_Holder_3-4ths.stl | 161.4KB | |
| Filament_Holder_v2_7-8ths.stl | 220.0KB | |
| Shelf_Bracket_3-4ths.stl | 131.7KB | |
| Shelf_Bracket_7-8ths.stl | 133.2KB |
