Yet another filament cutter for 1.75mm filament..
The filament is cut in an angle by sliding the blade forward.
Goal:
Fully printable small filament cutter. No need for springs, screws, washers, nuts or anything else that requires the correct dimensions. The only hardware is a blade from a standard box cutter (with snap-off blade). The snapped part should be 18mm..
I managed to design this from scratch with good functionality. I must admit that it was a little bigger than what I thought was necessary,, but it's printable and light weighted.
A short video:
https://youtu.be/8BqCJIh7eeQ
| Filament_cutter_base.stl | 146.5KB | |
| Filament_cutter_blade_holder.stl | 23.8KB | |
| Filament_cutter_push_end.stl | 2.4MB |
