I started collecting FigPins and really needed a better way to shelve them, so I measured the cases and built individual sleeves that can connect to form shelves. They fit like puzzle pieces so you can print and adjust them however you need! I display mine out of their sleeves, but in their cases, so the dimensions will fit that.
Command strips can be placed around the edges if you want to hang them on a wall, or they can lay flat.
The pictures attached are of the ones that I have printed so far. There is a middle connector piece that will allow you to build up for multi-level shelving as well. If you are looking for a single shelf, there is an option for that too!
| Bottom_Left_Corner.stl | 6.3KB | |
| Bottom_Middle.stl | 7.9KB | |
| Bottom_Right_Corner.stl | 6.3KB | |
| Connector.stl | 9.5KB | |
| End_Female.stl | 4.8KB | |
| End_Male.stl | 4.8KB | |
| Left_Side.stl | 7.9KB | |
| Middle.stl | 6.3KB | |
| Right_Side.stl | 7.9KB | |
| Single.stl | 3.2KB | |
| Top_Left_Corner.stl | 6.3KB | |
| Top_Middle.stl | 7.9KB | |
| Top_Right_Corner.stl | 6.3KB |
