FIG Nome (found In Garage) 3D Printer Model
The file 'FIG Nome (found In Garage) 3D Printer Model' is (stl) file type, size is 22.3MB.
The file 'FIG Nome (found In Garage) 3D Printer Model' is (stl) file type, size is 22.3MB.
I found this little guy in the garage of the house I rent.
He's a Garden gnome holding a red spotted mushroom & a spade.
Poor little bugger, he's seen better days, I did the best I could with scanning,
Scanned on Matter and Form Scanner, I'm not good at this yet, he's a bit rough, lolz.
I ran him through NetFabb to check any errors, he came up clean.
He's 150 mm High at 100%
gnome2.stl is a way better scan...
Go On, Hit the Like Button, it won't hurt a bit and would be very much appreciated :-)
| gnome2.stl | 25.1MB | |
| gnome_repaired.stl | 40.7MB |
