A neat fidget spiral sphere design using two identically shaped parts (one STL file, can print in 2 colors of your choice). Slide together in different ways to make some beautiful shapes or fidget.

Test printed and fits together beautifully. Generous clearances. Recommended to use a brim when printing for good build plate adhesion, 20% infill, and 3 walls (1.2mm wall thickness). See print settings for other tips. No supports needed. Check sliding surfaces are free from blobs after printing - do not force together.

"Secret" method to open: Once assembled press the top and bottom buttons simultaneously to extend the fingers and can then rotate the halves like a fidget.

Please post your makes photos.

PLEASE NOTE: the design license is Creative commons, Attribution, Non-Commercial, No Derivatives - you cannot sell this design or physical prints. Sharing without ATTRIBUTION (including link to this webpage) is not allowed. If sharing you cannot change the license type.

Check out my other designs: https://www.thingiverse.com/galaxy33/designs

⚠Warning⚠
Be careful in environments with young children and pets! This model contains small parts. If not properly stored in an environment with young children or pets, it may lead to accidents such as accidental ingestion or injury. If infants or pets are present, please take appropriate measures depending on the situation, such as refraining from 3D printing or storing in an appropriate place.

Do not apply strong force! Applying strong force to a 3D printed model or throwing it may damage the model and lead to accidents such as injuries. In addition, debris from damage to the model may be accidentally ingested by infants or pets. If the model is damaged, dispose of it immediately.

Store them in an appropriate place. After 3D printing, store the model in an appropriate place out of reach of young children and pets. Proper adherence to the precautions will ensure the safe use of the model.