I redesigned the original Fendt phone holder bracket to accommodate conventional phone holders in my case for the gadget me phone holder.
Additionally, I incorporated a hole in the bracket for mounting a USB charger. To supply power to the charger, I built a Y-adapter that draws electricity from the German plug located on the wire harness on the right side of the seat.

The Phone Charger I used can be found under the following link:
https://www.amazon.de/dp/B08QFJ7C87?ref=ppx_yo2ov_dt_b_fed_asin_title
All other Charger with the same dimensions will work.

If you enjoy my work, I'd appreciate a like !

Here’s how I completed the project:

1. Print the files using Bambulabs ABS-GF. 100% infill.

2. Sand everything down to smooth the surface.

3. After enlarging the holes to 8mm, I insert two Ruthex M6 threaded inserts, leaving a 1mm stand-off on each side. This helps prevent the part from breaking and provides a more secure attachment to the console.

4. Paint the parts matte black.

5. Insert the USB plug and tighten the screw from behind.
   Important: Ensure one of the grips on the screw is on the underside to allow proper lid alignment.

6. Solder the cables to the charger. Alternatively, you can use 90° standoff cable lugs. If using standard cable lugs, make sure to print the longer version of the lid.
   Attach the lid to the charger, securing it with superglue.

7. Isolate the cable with a cable loom and attached a two-pole German plug.

8. Insert the M4 threaded insert in the Knob. Insert the M4 screw in the Ball and secure it with superglue.

Note: I am not an electrician, so I won’t provide detailed instructions on building the Y-splitter. However, with a bit of knowledge, you should be able to figure it out easily—it’s fairly simple! ;-)

Material List:

For the Holder:

1 Usb Phone Charger
1 German Plug 2 pole male
1 Cable Red
1 Cable Black
2 Threaded inserts M6
1 Threaded insert M4
1 4,5mm Cable loom
1 M4 x 35 Hex Screw

Print files:
1 PhoneHolder_Bracket
1 Phone Holder_Lid
1 PhoneHolder_Ball
1 PhoneHolder_KnobM4

For the Splitter
3 Cable Red
3 Cable Black
1 Cable Green
1 Cable Yellow
1 German Plug 2 pole female
1 German Plug 4 pole male
1 German Plug 4 pole female

Print Files:
1 Cable_Splitter