Felder T-Nut Adapter Stier Clamp 3D Printer Model
The file 'Felder T-Nut Adapter Stier Clamp 3D Printer Model' is (skp,stl) file type, size is 93.8KB.
The file 'Felder T-Nut Adapter Stier Clamp 3D Printer Model' is (skp,stl) file type, size is 93.8KB.
This is an adapter to use a T-slot clamp in the larger Felder-slot. In my case I used this clamp:
STIER
Item no.: 63040555
Manufacturer number: 902998
But it should also work with other clamps that fit into a T-slot (12 x 8 mm)
The clamp has a very tight fit in the adapter and may need to be tapped a bit.
There are two holes on the side in which the clamp could be additionally fastened with grub screws, but this will probably not be necessary. There is also a hole on the top that gives you the option to drill a threaded hole in the clamp and connect the adapter and the clamp with a screw.
However, the adapter is so tight that I haven't attached the screws yet.
| Felder-Nuteinlage.skp | 115.1KB | |
| Felder-Nuteinlage.stl | 173.5KB |
