This is a remix of khattoum's great Fatman nuke model with a magnetic nose. I also sized each part of his model to 80%.
You will need 8 neodymium magnets measuring .25" in diameter and .06" thick. I used these ones; https://www.microcenter.com/product/455323/master-magnetics-magnets-with-adhesive-back-n-s-25-wide-12-pieces I just removed the adhesive backing. For the nose cone, they are completely contained in the nose. To insert them, I set up a layer pause and put them in before the layer which would cover the holes started.
The nose and upper half are the two I modified. Everything else is the same, just scaled down to 80%. At this scale, the tail is approximately 4.75" square, and it stands around 10.25" high
| Fatman_Antennae.stl | 4.6MB | |
| Fatman_Antennae_Pads_fixed.stl | 4.0KB | |
| Fatman_Arrays_1.stl | 2.5MB | |
| Fatman_Arrays_2.stl | 2.8MB | |
| Fatman_Bottom.stl | 29.0MB | |
| Fatman_Contact_Sensors.stl | 4.5MB | |
| Fatman_Handle.stl | 47.2KB | |
| Fatman_Lower_Clamps.stl | 422.7KB | |
| Fatman_Lower_Half.stl | 4.2MB | |
| Fatman_Nose_Cone.stl | 8.6MB | |
| Fatman_Tail_Assembly.stl | 110.2MB | |
| Fatman_Upper_Clamps_fixed.stl | 596.2KB | |
| Fatman_Upper_Half.stl | 13.6MB |
