FATBOY is a print test that you can use to test your 3D printer. Based on CreativeTools #3DBenchy, FATBOY is a ground up rebuild using all new files and it really floats!
I used a 1mm wall thickness with 25% infill but you can vary both to alter the position in water. Increasing weight will naturally make him sit lower but due to the position of infill increasing this will also alter the pitch.
Have fun!
| FATBOY.stl | 3.4MB | |
| FATBOY_CAB.stl | 508.6KB | |
| FATBOY_DECK.stl | 73.9KB | |
| FATBOY_FISHROD.stl | 53.2KB | |
| FATBOY_GUNWALE.stl | 1.0MB | |
| FATBOY_HAWSE.stl | 86.6KB | |
| FATBOY_HULL.stl | 1.8MB |
