Fast Refiller For Common Soap Dispensers 3D Printer Model
The file 'Fast Refiller For Common Soap Dispensers 3D Printer Model' is (stl) file type, size is 81.4KB.
The file 'Fast Refiller For Common Soap Dispensers 3D Printer Model' is (stl) file type, size is 81.4KB.
Next to the sink or not, common lipid or not, I finally had enough of ye olde refill messies.
Almost a direct pour: Snorkel on this design reduces 'glunking' times into seconds. =)
Use at your own risk. No supports required.
(Here is the Compact Edition )
Notes:
Two "Mickey Ear" holes permit drip-out hangings after refill 'ops.
Designed to fit <= 15mm diameter refill tubes.
Designed walls are ~2mm - should scale reasonably well.
Caveat funky tap-handles. Mine refill at an angle if I tip this - yours mayn’t.
This design is decently fast for common viscosities; we’ll usually needn’t wait more than a moment or three for most soaps to settle, even whilst pouring.
To prevent overflows be sure to wait until your soap dispenser is completely empty before measuring-out LESS (pumper replacement displacement) than any amount required to refill your same.
| FunOne_ROT.stl | 396.3KB |
