Hi i just created this connector for my other design MOVEO 6axis Robot to bring power and control this 6axis arm
This is a fast conector based on a industrial standard
Its fully 3d printable but i recomend you to cut the thin plates with carbon fiber (3mm)See Photo painted in red
This conector is desinged to be used for 3 modules of 40 pins each one max it could support 120pins
The female pins are from old computer Pci-e (from the motherboard to the harddrive to floppy to cd reader etc) I don't know the exact name you have to sand it a little bit and it will fit in i recomend you to fix with superglue
And the male pins are based on a board with the pins welded on it
Its designed to work with two cables of 60 pins right know i will use 2 of 40 pins each one
I will post all the data until this week
| Harting.STL | 1.2MB | |
| Harting_-_Female_connector_base-2.STL | 31.3KB | |
| Harting_-_Female_connector_base-3.STL | 31.3KB | |
| Harting_-_Female_connector_base-4.STL | 31.3KB | |
| Harting_-_HArting_Case-1.STL | 167.5KB | |
| Harting_-_Harting_ClampHarting-1.STL | 50.3KB | |
| Harting_-_Harting_ClampHarting-2.STL | 50.3KB | |
| Harting_-_Harting_Clamp_HandlerHarting-1.STL | 73.7KB | |
| Harting_-_Harting_Male-1.STL | 73.2KB | |
| Harting_-_Harting_WasherHarting-1.STL | 20.0KB | |
| Harting_-_Harting_WasherHarting-2.STL | 20.0KB | |
| Harting_-_Male_Harting_Case-1.STL | 391.4KB | |
| Harting_-_Male_Harting_Case_2-1.STL | 214.5KB |
