Fanatec Clubsport V3 Throttle Stiffness Mod Hall Effect Sensor Holder 3D Printer Model
The file 'Fanatec Clubsport V3 Throttle Stiffness Mod Hall Effect Sensor Holder 3D Printer Model' is (stl) file type, size is 18.1KB.
The file 'Fanatec Clubsport V3 Throttle Stiffness Mod Hall Effect Sensor Holder 3D Printer Model' is (stl) file type, size is 18.1KB.
While taking apart my pedals (again) for cleaning and relubing i noticed that there was a second position for the pin that holds the spring assembly of the throttle (the throttle and clutch are the same part, the hole is only used on the clutch).
You can just move the spring to that upper position, making the throw much shorter and the pedal much much stiffer.
This bracket lets you move the hall effect board right over the new position of the pin with the magnet. A M6 and M8 screw is needed for the attachment. Holes are sized so the screw digs into the print.
!! DISCLAIMER !!Since the hall effect sensor relies on rotation of said pin, moving the pin higher in the pedal makes it rotate quite a bit less. Even with recalibration you have a deadzone of about 5mm to a cm on the start of the pedal, which is more than 25% of the total travel of the pedal after the adjustment.
Wasn't a problem for me but i just want to point that out right away.
| Body1.stl | 72.7KB |
