Fanatec ClubSport Handbrake Cable Protector 3D Printer Model
The file 'Fanatec ClubSport Handbrake Cable Protector 3D Printer Model' is (stl) file type, size is 130.1KB.
The file 'Fanatec ClubSport Handbrake Cable Protector 3D Printer Model' is (stl) file type, size is 130.1KB.
This is a cable/connector protector for the Fanatec Clubsport Handbrake.
For this protector there is no case mod needed.
Just remove the screw and cable. Put the cover with the one side into the two screw holes. Then attach it with the original screw. After that plug in the cable again.
V2
I created a v2 for both the left and right protector in which the cable connector is fully enclosed and thus protected from all sides. Cable still inserts easily (just push it carefully straight down), making sure it's in all the way - the end of the connector should be flush with the end of the protector.
| Fanate_Handbrake_Left_Mounted.stl | 97.9KB | |
| Fanate_Handbrake_Left_Mounted_V2.stl | 123.9KB | |
| Fanate_Handbrake_Right_Mounted.stl | 71.4KB | |
| Fanate_Handbrake_Right_Mounted_V2.stl | 104.7KB |
