I made this from other things here. It is made to use two 608 skate bearings in the sides, and I used pins to connect the center to the bearings. You could also use a threaded rod thru the whole thing. There is certainly room for improvement, but it works for my spools. And I will be moving on to another project. The units are in inches. Scale the parts by 25.4 for MM.
| 608_core1_pin.stl | 3.1MB | |
| 608_core2_knob_plug.stl | 4.3MB | |
| fallout_spindle_brace.stl | 1.1MB | |
| fallout_spindle_end.stl | 556.5KB | |
| fallout_spindle_extension.stl | 1.0MB | |
| fallout_spindle_knob.stl | 1.5MB | |
| fallout_spindle_side.stl | 3.0MB | |
| fallout_spindle_thread.stl | 1.7MB |
