Simple Fairy Wand, just the handle and the magic star.
Your provide a 10mm wooden rod for the shaft.
Update: added printable "rod" in three parts.
Update: added lay-flat star for easier printing. This has two parts so you can print in separate colors or with a color-change
Assemble, spray with adhesive glue, and cover with glitter.
Spray with clear acrylic to prevent the glitter litter.
Print upright at 0.2 mm layer height; the bottom where the shaft goes in has a single-layer membrane to give good bed adhesion and can be easily trimmed after printing.
Print star with supports at about 35 degrees; this will give the two bottom arms of the star just enough help to print easily, and are also easily removed.
Alternately, print tow of the "lay flat" stars and glue together.
To use the rod, print three of the rod segments in color(s) of your choice and glue together.
| Fairy_Wand-handle.stl | 2.1MB | |
| Fairy_Wand.stl | 1.5MB | |
| Fairy_Wand_v4.f3d | 1.0MB | |
| Star_layflat_Base.stl | 682.4KB | |
| Star_layflat_Front.stl | 141.4KB | |
| wand_rod.stl | 9.3KB |
