Factorio Diorama 3D Printer Model
The file 'Factorio Diorama 3D Printer Model' is (stl) file type, size is 31.1 MB.
The file 'Factorio Diorama 3D Printer Model' is (stl) file type, size is 31.1 MB.
should print mostly without supports
use the little groves in the backplate to line up the letters and the backplate might need a little sanding on the feet to slot into the top of the poles
I was able to print the power poles without supports at .2mm but I did use Z-hop
the biter can be a little tricky to make small
Edited some files there were mistakes/easier to print models
I also added a combined letter plate for pausing the print to switch filaments to orange
Edit2
Added a tileable base with the train to slide on the tracks.
Added rotating turrets
Added a FDM friendly biter use a heat gun or warm water to gently bend legs into poses.
Tip: I highly recommend using PVA (Elmers) glue just smear a coating on the base and sprinkle some sand or dirt on to create the terrain
| Factorio_Biter.stl |
| Factorio_Biter_small_body_FDM.stl |
| Factorio_Biter_small_Legs_FDM.stl |
| factorio_display.stl |
| factorio_display_backplate.stl |
| factorio_display_letters.stl |
| factorio_display_letters_plate_combined.stl |
| factorio_display_poles.stl |
| Factorio_Gun_Turret_Mini.stl |
| Factorio_Laser_Turret_Mini.stl |
| Factorio_power_pole_of_EXTRA_beefiness.stl |
| Factorio_Train_display_Segment_No_Bumps.stl |
| Factorio_Train_display_Segment_With_Markers.stl |
| Factorio_Train_display_Train_Slide.stl |
