Aim was to upgrade fabrikator to a closed chamber, to have a constant t° for printing.
This is lessimportant for PLA, but is important for ABS, Polycabronate.
Also it has reduce the noice a lot.
It's still possible to access from the top easly
You need to drill your slef the holes, and trace it (easy)
What's needed:
Plexiglass 4mm:
Left part: 20 x 24 cm
Right Part: 20 x 24 cm (do not insert screw in top right, ot od not block stepper motor)
Top:
24.5 x 5 cm (Two times)
21 x 5 cm (Two times)
24.3 x 21.8 (drill in center 6mm)
Front door:
26 x 22.5 cm
26 x 4 cm
I used 7x M3 nylon + bolts for the sides
16x 2,9mm x 9.5 mm metal screw
Print following parts:
1x door lock
2x charnière
4x coin
4x supportcote
2x Support_90_long
2x Support_90_court
See pictures for assembly
Usage:
for pla i keep t° inside arround 31°C,
1 Layer 63°C
Other 40°C
Door open 2cm.
| charnière3.stl | 252.2KB | |
| coin.stl | 286.1KB | |
| DoorLockPrinter.stl | 149.1KB | |
| supportcote.stl | 173.0KB | |
| Support_90_court.stl | 186.7KB | |
| Support_90_long.stl | 176.3KB |
