Friction cruise control for F800gs.

Printed from PLA, still works fine after 1 year of use.
Cable housing side is attached to housing with two sided 3m sticky tape.
First install cable housing side with two sided tape (check orientation on my video, I think it's most comfortable position) and then install grip side with some lubricant (water+soap) so it will slide more easily.

• I printed it with 0.1mm layer height (with 0.4mm nozzle)
• From time to time I lubricate gap between grip and cruise control lever, so it works smoothly (like a drop of oil while checking oil level..)

I use not standard heated grips so gap between grip and cable housing can be different from original, if needed adjust thickness of parts.

GOOD LUCK!