F-111E Aardvark Kit Card 3D Printer Model
The file 'F-111E Aardvark Kit Card 3D Printer Model' is (stl) file type, size is 882.6KB.
The file 'F-111E Aardvark Kit Card 3D Printer Model' is (stl) file type, size is 882.6KB.
The F-111 Aardvark is a variable-sweep wing, supersonic, attack/bomber aircraft developed by General Dynamics. It entered service in 1967 in the USAF, and 1973 in the Royal Australian Air Force. With complications holding back the D variant the F-111E was devised as a simpler solution with upgraded intakes, avionics, and weapons systems. The Aardvarks was retired in 1996 by the USAF and replaced by the F-15E and B-1. Australia retired theirs in 2010.
For best results print at 0.20mm layer height and %100 infill. Anything else and the kit card may not fit together correctly. Both Sprue and Sprue-less models included along with the individual parts. This kit card requires no glue. If you are printing with the individual parts you will want:
Body A x1
Body B x1
Wing L/R x1
Fuselage/Fuselage Landing Gear x1
Engine/Engine Landing Gear L/R x1
| F-111E_Aardvark_No_Sprue.stl | 515.4KB | |
| F-111E_Aardvark_No_Sprue_Landing_Gear.stl | 602.4KB | |
| F-111E_Aardvark_Sprue.stl | 729.2KB | |
| F-111E_Aardvark_Sprue_Landing_Gear.stl | 800.1KB | |
| F-111_Aardvark_Body_A.stl | 61.0KB | |
| F-111_Aardvark_Body_B.stl | 90.7KB | |
| F-111_Aardvark_Engine_Left.stl | 45.3KB | |
| F-111_Aardvark_Engine_Left_Landing_Gear.stl | 74.5KB | |
| F-111_Aardvark_Engine_Right.stl | 46.4KB | |
| F-111_Aardvark_Engine_Right_Landing_Gear.stl | 75.6KB | |
| F-111_Aardvark_Fuselage.stl | 90.7KB | |
| F-111_Aardvark_Fuselage_Landing_Gear.stl | 119.3KB | |
| F-111_Aardvark_Wing_Left.stl | 91.1KB | |
| F-111_Aardvark_Wing_Right.stl | 90.7KB |
