Ezra Bridger’s Lightsaber 3D Printer Model
The file 'Ezra Bridger’s Lightsaber 3D Printer Model' is (stl,zip) file type, size is 1.9 MB.
The file 'Ezra Bridger’s Lightsaber 3D Printer Model' is (stl,zip) file type, size is 1.9 MB.
My kids and I are big Star Wars Rebels fans. There are many lightsabers on Thingiverse but I was surprised not to find this one. So...this is my rendition of Ezra Bridger's lightsaber.
This is a sizable project, with at least 25 parts (depending on configuration), and measuring about 9.25" x 5.5". The silver clip in the front is removable, per my son's request, and fastens with two 8mm magnets located in the bridge at the bottom. I have also included a peg to print if you choose to forgo the magnets and permenantly attach the clip. The tolerances and pretty tight between the pieces, so all the parts should fit nice and snug.
| back-block-bottom.stl |
| back-block-top.stl |
| blaster-barrel-ring.stl |
| blaster-barrel.stl |
| blaster-body.stl |
| blaster-casing.stl |
| blaster-clip-to-bridge-peg.stl |
| blaster-clip-to-bridge.stl |
| blaster-clip.stl |
| blaster-fastner.stl |
| blaster-shield.stl |
| bridge-screw.stl |
| d-ring.stl |
| emitter-assembly.stl |
| emitter-bottom.stl |
| emitter-shield.stl |
| emitter-top.stl |
| ezra-lightsaber-all-parts.zip |
| hilt-bridge.stl |
| hilt-handle-assembly.stl |
| hilt-handle-bottom.stl |
| hilt-handle-inner-ring.stl |
| hilt-handle-outer-ring.stl |
| hilt-handle-top.stl |
| hilt-top.stl |
| hilt-trigger-housing.stl |
| pommel-bottom.stl |
| pommel-peg.stl |
| pommel-top.stl |
| switch-fastner.stl |
| switch.stl |
| trigger.stl |
