here is an easy print box mod i have designed for use in parallel and series,
there is room for different wiring configs but in the pics it is wired in parallel using the parts listed below.
similarly the cutouts for the 510 and the button are also for the parts below, but for note the switch hole on right side is 12mm and the 510 is 10.5mm (space for an m10 thread)
cover and box are also precut for magnets but i found they were not needed so never installed, magnets also listed below
switchfet v2.5 -
http://www.modmaker.co.uk/Switchfet-V2.5 (mosfet)
510 connector -
http://www.modmaker.co.uk/Fat-Daddy-Vapes-510-V3-Short-Body?search=Fat%20Daddy%20Vapes%20510%20V3%20Short%20Body
i used the contacts from one of these sleds -
http://www.modmaker.co.uk/Blossom-1048-Dual-18650-Battery-Holder?search=Blossom%201048%20Dual%2018650%20Battery%20Holder
the wiring diagram for the mosfet is included on the site linked, i used it as it has reverse polarity protection and low voltage protection
the drip tip included is made to fit this blank (not needed but looks pretty :D) -
http://www.modmaker.co.uk/510-Drip-Tip-Blanks-10mm?search=510%20Drip%20Tip%20Blanks%20%2810mm%29
NOTE
dealing with electrics and batteries is dangerous, please use utmost caution when building this, and triple check every connection made to make sure there are no issues.
any issues are at the users discretion... you have been warned!
Enjoy! :D
| box_v2.stl | 356.2KB | |
| cover_v2.stl | 74.9KB | |
| drip_tip_v2.stl | 609.1KB |
