Extremely Inexpensive Stringing Test 3D Printer Model
The file 'Extremely Inexpensive Stringing Test 3D Printer Model' is (stl) file type, size is 13.7KB.
The file 'Extremely Inexpensive Stringing Test 3D Printer Model' is (stl) file type, size is 13.7KB.
This is a very simple, inexpensive, and fast-to-print stringing test.
It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s.
The gab is about 3 cm wide.
As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+:
Printing temperature 207 C°
Use ramping lift yes
Maximum ramping lift 0.9 mm
Ramping slope angle 1°
Retraction length 2.5 mm
Retraction Speed 65 mm/s
Retract on layer change yes
Wipe while retracting yes
Retract amount before wipe 70%
I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.
| Extremely_inexpensive_stringing_test.stl | 56.9KB |
