Extra Pieces For Marble Ramp DIY (Split, Bridge, Etc.) 3D Printer Model
The file 'Extra Pieces For Marble Ramp DIY (Split, Bridge, Etc.) 3D Printer Model' is (stl) file type, size is 3.3MB.
The file 'Extra Pieces For Marble Ramp DIY (Split, Bridge, Etc.) 3D Printer Model' is (stl) file type, size is 3.3MB.
Some new pieces for "Marble ramp DIY". Not really a remix (modeled from scratch), but close enough :)
Split: Makes the marble go left or right - Two versions (high and low/V2).
Joiner: Makes too marble paths join together. Note: This also works as both a normal left OR right curve. So instead of printing left/right curves, you can just print this piece instead!
Bridge: Can be placed on top of other pieces to provide a bridge over any 'flat' piece. Note: This piece requires supports under it, and a secure brim around the base since it is so thin at the base. Also, you can't place two of these next to each-other (they won't fit).
Lifter 1 and Lifter 3 remake that prints with less cleanup in the 'sockets' on the underside.
| BridgePiece.stl | 586.7KB | |
| Joiner.stl | 1.5MB | |
| Lifter1_Remake.stl | 235.4KB | |
| Lifter3_Remake.stl | 235.4KB | |
| SplitPiece.stl | 3.4MB | |
| SplitPieceV2.stl | 1.7MB |
