I really like the game dimension https://www.boardgamegeek.com/boardgame/153318/dimension but it only plays up to 4 players due to the limitation of boards and balls.
So I am going to remove the insert and put two more sets of board + 12 balls needed for each player to take it up to a 6 player game.
I will likely buy 25mm marbles for the balls, but I provided an .stl of a 25mm sphere. With supports and some filing/sanding it should print out okay. (lift it off the bed plate for better results).
Since I have a lulzbot mini, I only have about a 6 inch cube to print in, and this had to be split into 4 sections for me to print. I supplied those .stl files as well. I am going to print this in ABS and solvent weld it together with acetone slurry (acetone mixed with abs). I have done similar things before and it works fairly well. It helps if you do it on something safe like wax paper and then after you can put another piece on top and set something heavy on it to make sure it solidifies nice and flat.
I will buy some foam pads from home depot or similar store to raise it up. I could have included them in the print, but I would rather they not be made out of abs.
| dimensions_ball.stl | 440.7KB | |
| dimensions_board.stl | 501.4KB | |
| dimension_1a.stl | 245.9KB | |
| dimension_2a.stl | 175.1KB | |
| dimension_3a.stl | 98.7KB | |
| dimension_4a.stl | 207.9KB |
