Extendable Ladder For Parakeet, Cockatiel, Bird. No Glue Required! 3D Printer Model
The file 'Extendable Ladder For Parakeet, Cockatiel, Bird. No Glue Required! 3D Printer Model' is (stl) file type, size is 42.9KB.
The file 'Extendable Ladder For Parakeet, Cockatiel, Bird. No Glue Required! 3D Printer Model' is (stl) file type, size is 42.9KB.
Make this ladder as long or as short as you (and your bird) want!
This is a bird ladder that will clip onto a 1/2 inch perch, or rest on a cage wall. There are two different widths.
The shortest ladder can be printed by simply printing the left side ladder, right side ladder, and two of the rungs - either regular or long.
IMPORTANT - you will find a notch near the end of each rung. Make sure this notch is facing down (the bottom of the ladder) when you insert into the hole. It may take quite a bit of pressure to insert the rung, but you will hear a click when it is in place.Once both sides of the ladder have the rungs inserted, you can press on the sides to make sure every rung is clicked into place.
Each new section adds about 30mm and one rung to the ladder. Pieces are designed to fit tightly, so you may need to press hard.
| parakeet_ladder_4_rungs_regular.stl | 81.3KB | |
| parakeet_ladder_4_rungs_wide.stl | 81.3KB | |
| parakeet_ladder_left_side.stl | 20.0KB | |
| parakeet_ladder_right_side.stl | 20.0KB | |
| parakeet_ladder_rung.stl | 5.4KB | |
| parakeet_ladder_rung_long.stl | 6.3KB | |
| parakeet_ladder_section.stl | 5.2KB |
