Exo-Suit (Part 2: Torso) 3D Printer Model
The file 'Exo-Suit (Part 2: Torso) 3D Printer Model' is (stl) file type, size is 5.6MB.
The file 'Exo-Suit (Part 2: Torso) 3D Printer Model' is (stl) file type, size is 5.6MB.
PART 2: Torso.
You can find Part 1 here:http://www.thingiverse.com/thing:1471866
If you have been working on part 1, you will have to audit the parts you have made. Some of them are no longer needed for this addition/update. Some of the parts are swapped out and used elsewhere.
This addition features hinges on the front and back to get in and out, and a "quick release" pull-pin.
This part is assembled in the same manner as PART 1, using pins to hold it all together. You will also need to print out a few of the Male Coupler pieces for connecting the Chest 6 Half and the "T's" to the back verticle drop pieces. This will be self-explanatory during assembly.
Note: The hinges should be printed at 100% infill with supports touching build plate. The pull Pin needs to be printed with supports everywhere.
| 100mm_90.stl | 3.0MB | |
| 4_way_coupler.stl | 261.8KB | |
| 75mm_FM_coupler.stl | 175.7KB | |
| bearing_plug.stl | 621.2KB | |
| Body_back_vertial_drop.stl | 225.5KB | |
| chest_6_half.stl | 187.1KB | |
| hinge_set.stl | 1.8MB | |
| Large_Pin.stl | 2.7MB | |
| lower_back_with_pivot_B.stl | 1.3MB | |
| Male_coupler.stl | 677.6KB | |
| release_pin.stl | 1.9MB | |
| Torso_front.stl | 1.6MB | |
| T_narrow.stl | 200.9KB | |
| Upper_back_Connector.stl | 534.8KB |
