I tweaked jgoldshlag's Abbadon model slightly to make it more print friendly. Some of the overhang geometry has been softened so that it does not require supports, the thin antenna have been thickened a bit, etc.
Both the Blender files as well as the STL files are included.
I printed this at 350% scale, the largest my printer could fit. It came out roughly 17 inches long.
| abaddon_middle.stl | 81.3KB | |
| Abbadon_Front_Rework.blend | 1.6MB | |
| Abbadon_Front_Rework.stl | 201.6KB | |
| Abbadon_Rear_Rework.blend | 1.4MB | |
| Abbadon_Rear_Rework.stl | 183.8KB |
