I designed this ethernet cable label holder for my IP cameras that are plugged into my POE switch.
They will slip on to the ethernet cable then slide up and over the end of the rj45 connector. This holds the label straight.
The label holder face measures 12X25mm’s. 12mm’s wide so it fits a DYMO label.
I put 4 on a common brim for easy printing. Trim apart post print.
It’s a very easy print but there are a lot of retractions
Printed in PLA, .2 layer, 25% infill
| ethernet_cable_label_holder.stl | 59.3KB |
