Et Tu, Plumbum? – Julius Caesar Pencil Holder 3D Printer Model
The file 'Et Tu, Plumbum? – Julius Caesar Pencil Holder 3D Printer Model' is (STL) file type, size is 2.3MB.
The file 'Et Tu, Plumbum? – Julius Caesar Pencil Holder 3D Printer Model' is (STL) file type, size is 2.3MB.
This was inspired by an online image of a Julius Caesar pencil holder someone made, where it looked like they must have drilled two dozen holes in it. I didn't like the bust used for that model, but I did find this one at MyMiniFactory. I used Meshlab to bring the faces down from over 1 million to 50k. I cut off the base and added my own. My original test piece did not have the base and a lower angel for the pencils, so it couldn't hold the weight.
The text is "And you, lead (Pencil)? For the fans of Caesar and pencils.....
I printed my test piece with the built-in support I made. I made it large because I hate when they fall over and you waste more material on a bad print than on skimpy support. There is a non-support version for those who prefer it that way. The test print pictures are just proof of concept.
If my print of this goes well today, I may try a larger version with more holes... or it's onto version 3.
Enjoy!
| et_tu_plumbum_No_Support.STL | 2.6MB | |
| et_tu_plumbum_Support.STL | 2.6MB |
![[L3GO] Brick / Block Compatible Spraycan 3D Printer Model](https://cdn.3axis.co/assets/51/9e/db/e2/519edbe2-28ba-4708-838d-429a4390dbda/images/5613a19d-2409-4dcf-956e-16747be14a4a_thumb.jpg)
