Photo shows the base and insert assembled with the pogo pins and some very sloppy gel CA glue :/
the "cap" has a routing void for the wiring to exit from the alignment hole.
the "guide" was designed to drop in a bare module board and get you close to alignment but I don't think I'll end up using it.
Oops - You'll want to flip the cap piece and rotate the insert before printing obviously :)
Uses pins like this:
http://www.ebay.com/itm/100Pcs-P75-B1-Dia-1-02mm-Length-15-85mm-100g-Spring-Test-Probe-Pogo-Pin-Tool-/321893993363?hash=item4af2608b93:g:NXYAAOSwhcJWH0ET
enjoy!
| ESP-8266_bed_of_nails_jig_base.stl | 79.4KB | |
| ESP-8266_bed_of_nails_jig_cap.stl | 226.5KB | |
| ESP-8266_bed_of_nails_jig_guide.stl | 31.1KB | |
| ESP-8266_bed_of_nails_jig_insert.stl | 13.2KB |
