ESP32 Devkit V4 Snap-Fit Case 3D Printer Model

Author: @
License: CC BY-NC
File formats: FCStd,stl
Download type: zip
Size:1.1MB

The file 'ESP32 Devkit V4 Snap-Fit Case 3D Printer Model' is (FCStd,stl) file type, size is 1.1MB.

Summary

This is a Snap-Fit Case for the latest ESP32 Devkit v4, which has (compared to the Devkit v1) a smaller PCB without screwholes and where the antenna is sticking out. As far as i can tell, there are no other cases for the the Devkit v4, which i why i made a custom one.

Features:

  • hole for status LED
  • two integrated buttons
  • snap-fit top and bottom shells
  • pin breakout supported (male & female)
  • both STL's and FreeCAD files

Configuration:

  • fully enclosed (no pin breakout, just the bare board in a case)
  • pin breakout to the bottom (breadboard compatibililty)
  • pin breakout to the top (typically usefull for projects)

...just pick the corresponding top and bottom part for the case.

Note:

  • Wether you want to use male or female pin headers is your choice and most likely depends on you projects configuration and needs. The dimensions in the pin-breakout allow for both, as they are of the same size.

  • The Snap-Fit mechanism requires some force to close and a spunger to being opened again. The tolerance is very small, so that even a small over-extrusion might make it to tight.

Enjoy!

ESP32_Devkit_v4_Snap_Fit_Case_Bottom.FCStd 65.2KB
ESP32_Devkit_v4_Snap_Fit_Case_Bottom.stl 44.0KB
ESP32_Devkit_v4_Snap_Fit_Case_Bottom_Pin_Breakout.FCStd 96.3KB
ESP32_Devkit_v4_Snap_Fit_Case_Bottom_Pin_Breakout.stl 56.9KB
ESP32_Devkit_v4_Snap_Fit_Case_Top.FCStd 430.8KB
ESP32_Devkit_v4_Snap_Fit_Case_Top.stl 101.4KB
ESP32_Devkit_v4_Snap_Fit_Case_Top_Pin_Breakout.FCStd 471.0KB
ESP32_Devkit_v4_Snap_Fit_Case_Top_Pin_Breakout.stl 102.8KB