ESP32 2.8inch Touch IPS CYD LCD Screen Case

I recently purchase this screen from Ali Express.
It has a very unimaginative name "ESP32-2432S028R" which makes it hard to find.
For that reason it is also known as the Cheap Yellow Display CYD
RCmall 2.8'' ESP32 Module ESP32-2432S028R 240*320 Smart Display Screen 2.8inch LCD TFT Module ILI9341 Driver

It's a nice 240 x 320 TFT screen that looks good and is with resistive touch.

I decided to model a close fitting case with a rear cover that snap fits to the front case portion.

The case is a snug fit around the pcb so depending on your printer it may be necessary to allow more clearance around the pcb.

If that is the case then it is recommended to increase the scale of the front case and the rear cover in your slicer software. Or amend the files.

The rear cover has spacer legs on each corner to hold the pcb in position.
The leg height may need tuning to your printer.

A separate stand file is included to enable the case to sit tilted to 60 degrees.

Separate files are also included for the Front Case with no holes (except micro USB)

Printed at 0.20mm with no supports required on a Prusa Mini+.

STEP files are included should you need to make amendments.

Hope this helps someone.

Amendment #1 12Nov23
Added files for the case with hole for the LDR (Light Dependant) Resistor 21 to operate properly.