To build this nib holder, please follow below guide:
Parts or tools required:
- Oblique flange (Dip pen flange)
Go search in Ebay or AliExpress.- 2mm Drill Bit (Optional)
- Hacksaw with nearly 1mm thick blade (Optional)
Build steps:
- Print the nib holder and get the parts. Please prevent to put supports in the slot.
- Push flange into the slot of nib holder.
- (Optional) You may need to use the 2mm Drill Bit to make the center hole larger and remove support/waste in the center hole
- (Optional) You may need to use the hacksaw to saw a little bit if there any support/waste in the slot.
- After push flange into the slot of nib holder, you can put your favorite nib and start writing!
Feel free to remix and thanks for making this.
| Pen_Nib_Holder.stl | 2.0MB |
