low-poly Eldar Avatar model for Epic. 1/2 a step up from the 'flat' models (extruded silhouette).
nothing special but gets a model on the table. may or may not look better painted based on your definition of 'better'. will put up a pic this evening but don't expect miracles.
uses a dreadnought sized base (20mm x 20mm).
i recommend scaling this to about 140%-150% for printing as the STL content is possible a little too small.
i noticed that my printer though this was 100% inside out, not sure why as it was netfabbed. also netfabb decided to make it left-handed (mirror) but my care factor is extremely low regarding this.
| avatarProxy_repaired.stl | 31.0KB |
