I remixed the Hesi-Re Ender-5 station to support the mounting pin layout of the BTT Pi v1.2.
The holes of this remix might be slightly smaller than the original. I used M2 self tapping screws and it seems to be holding just fine. I think it could support up to M2.5 screws and cut their own threads, but I haven't tried this. But I am certain M3 is too big. They won't fit in the holes of the btt pi. (but just barely)
When installing the pi into the housing, remember to attach your antennae to the bottom of the pi before screwing the thing down. Also, remember to remove the jumper as mentioned in the BTT pi user manual if you are going to provide power via the screw terminals.
I ended up sticking the antanae sticker to a spot inside the plastic housing and it seems to be working fine.
The LCD panel portion takes M3 screws. I think I used M3x12, but It might have been slightly longer or shorter.
For wiring information, check the BTT Pi github. There is a user manual there.
| ender-5-pi-station-remix.stl | 645.9KB |
![[Remix] CR-10 Fan Mod 3D Printer Model](https://cdn.3axis.co/assets/01/3c/80/39/013c8039-4123-4419-8d92-a6c862619f7d/images/b659cf07-c59d-42a4-8477-f6128dc40c99_thumb.jpg)
